ABB ACS880 Series Quick Start Up Guide

Error codes for FB500 and FC500
DP-V0 error table
Task cannot be executed, you can follow by error number.
Error no.
Description
0
Illegal parameter number
1
Parameter value cannot be changed
2
Lower or upper limit violated
3
Erroneous subindex
4
No array
5
Incorrect data type
6
Setting not allowed (can only be reset)
7
Descriptive element cannot be changed
9
Descriptive data not available
11
No parameter changes rights
15
Text array not available
17
Task cannot be executed due to operating status
(e.g. parameter is currently read-only)
18
Other error
101
Vendor specific error
102
Request not supported
103
Request cannot be completed due to communication error
110
Failure during write to non-volatile memory
111
Request aborted due to time-out
120
Parameter cannot be mapped to PZD
(size mismatch or non-existent)
121
Parameter cannot be mapped to PZD (end of memory)
122
Parameter cannot be mapped to PZD (multiple PZD write)
130
Cannot map Control Word bit (parameter 933-937, e.g. double
mapping of bits)

ABB ACS880 Series Specifications

General

Cooling Method	Air-cooled, liquid-cooled
Enclosure class	IP21, IP55
Mounting type	Wall-mounted
Control method	Direct torque control (DTC)
Braking chopper	Integrated or external
Communication	Ethernet
Protection Features	Overcurrent, overvoltage, undervoltage, overload, short circuit, overtemperature, earth fault
Operating Temperature Range	-15°C to +50°C
Storage Temperature Range	-40°C to +70°C
Relative Humidity	5 ... 95 % (non-condensing)
Safety features	Safe torque off (STO)