ABB ACS880 Series Quick Start Up Guide

5. In the Device view, select PLC_1 (DP interface). In the General tab, select PROFIBUS
address and click Add new subnet to add the subnet and then assign PROFIBUS address.
Figure 114 DP interface
6. After configuring PROFINET and PROFIBUS interfaces in TIA portal, click Network view to
view the PLC connections.
Figure 115 PROFIBUS and PROFINET configurations
Installing GSD file for S7-1200 PLC
To install GSD file, see section Installing GSD file for S7-300 PLC (page 79).

ABB ACS880 Series Specifications

General

Cooling Method	Air-cooled, liquid-cooled
Enclosure class	IP21, IP55
Mounting type	Wall-mounted
Control method	Direct torque control (DTC)
Braking chopper	Integrated or external
Communication	Ethernet
Protection Features	Overcurrent, overvoltage, undervoltage, overload, short circuit, overtemperature, earth fault
Operating Temperature Range	-15°C to +50°C
Storage Temperature Range	-40°C to +70°C
Relative Humidity	5 ... 95 % (non-condensing)
Safety features	Safe torque off (STO)