Allen-Bradley PowerFlex 40 User Manual

91Publication IASIMP-QS001C-EN-P - October 2009 91
Chapter 9
Configure the DeviceNet Network
In this chapter, you configure the DeviceNet node address for the 1769-SDN module. You
also create the RSNetWorx for DeviceNet file that stores network configuration.
Before You Begin
• Prepare the computer, see Chapter 2.
• Install all hardware, see Chapters 1
–6.
• Connect the 1769-SDN module, the 1734-ADN adapter and the PowerFlex drives to a
DeviceNet network.
This example uses KwikLink right-angle male cables with sealed micro connectors
connected to flat cable with terminator/resistors on each end.
• Verify that power is applied to all devices.
What You Need
• Power supply and tap for the DeviceNet network.
This example uses the 1606-XLDNET8 and a KwikLink power tap module.
• RSNetWorx for DeviceNet software.

Allen-Bradley PowerFlex 40 Specifications

General

Brand	Allen-Bradley
Model	PowerFlex 40
Category	Controller
Language	English