LTP51 H EN Safety and operating instructions
© Atlas Copco Industrial Technique AB - 9836 938172 72
3
Safety and operating instructions
Safety instructions
Warning
Make sure you are familiar with the operating instructions before you use this
machine.
The machine, together with any attachments and accessories, must never be
used for anything other than the designated purpose.
All locally legislated safety rules with regard to installation, operation and
maintenance shall be respected at all times.
Refer installation and servicing to qualified personnel only.
Before making any adjustments (e.g. changing sockets) disconnect the machine
from the compressed air line.
Check the direction of the rotation before using the machine.
Operators of nutrunners with a torque reaction bar should take particular care to
avoid injuries due to squeezing. For safety reasons – never allow anyone to op-
erate the machine unless he is trained and thoroughly familiar with how the ma-
chine works in different circumstances. Refer to the section headed “Reaction
bar”.
The machine may only be used together with the associated torque reaction
bar which is adapted to the screw joint application concerned. See also the in-
structions under the heading “Reaction bar”.
Never put your hand on or close to the reaction bar while the machine is be-
ing used.
Check that the power socket is properly fastened. Replace the retaining or lock-
ing pin when necessary. Also replace any worn socket.
Keep hands, long hair or other objects away from the rotating socket.
Do not use gloves.
When using a suspension yoke, check that it is in good condition and correctly
fastened.
General information
EC DECLARATION OF CONFORMITY
We, Atlas Copco Industrial Technique AB, S-105 23 STOCKHOLM, SWE-
DEN declare that the product (with name, type and serial number, see front
page) is in conformity with the following Directive(s):
2006/42/EC
Harmonised standards applied:
EN 792-6
Technical file available from:
Quality Manager, Atlas Copco Industrial Technique, Stockholm, Sweden
Stockholm, 1 July 2013
Tobias Hahn, Managing Director
To Next Page
Loading...
Need help?
General
