Enterprise Survivable Servers - Maintenance Commands
Issue 1.1 June 2005 149
disable ess command Error Codes
enable ess
S8700 | 8710 | S8710 | S8500
enable ess [ all | cluster n <1-999> ]
Use enable ess to enable a Main server or ESS server’s ability to connect to IPSIs in Port
Networks.
Note:
Note: A server cluster is a either a S8500 or S8700 | 8710.
Use enable ess from either a Main server or an ESS server. An ESS server may enable only
its own cluster ID. When enable ess is run from the Main server, any and all cluster IDs may
be enabled including the Main server itself.
When enable ess cluster <ess cluster n> is run:
● if it is enabled, the ESS server does nothing. The TEST RESULTS screen indicates that
test 1606 passed for the ESS server. See Figure 43: disable ess command TEST
RESULTS example on page 148.
● if it is disabled, the ESS server changes its state to enabled and:
- removes its translations.
-performs a reset system 4 operation.
- registers with the Main server once the reset is complete.
- receives a download of translations from the Main server.
- resets a second time (after the translation download is complete).
disable ess command Error Codes
Error Code Description
1991 ESS cluster not administered
1992 ESS cluster not registered
1993 ESS cluster controlling IPSIs (Port Networks)
1994 ESS cluster (non-main) may not disable other clusters (ESS server or
Main server)
2500 Internal operation failed
To Next Page
Loading...
Need help?
General
