Enterprise Survivable Servers - Maintenance Commands
Issue 1.1 June 2005 155
Figure 47: status ess clusters command example - ESS
status ess clusters field descriptions
Note:
Note: The field definitions are the same whether the status ess command is
executed on a Main server or ESS server.
status ess clusters
Cluster ID 60 ESS CLUSTER INFORMATION
Active
Cluster Server Translations Software
ID Enabled? ID Registered? Updated Version
60 y 90 y 11:02 3/7/2005 R013x.00.0.338.0
status ess clusters
Field Description
Cluster ID
(title line)
Cluster IDentifier (1 - 999). The cluster identifier of the server where
status ess was run. In a duplex server environment (
S8700 | 8710) both
the active and the standby server have the same cluster ID. The cluster ID
is initially obtained from the license file (where it is called the Module ID or
MID). Once save translation is executed, the cluster ID is saved in
translations.
Cluster ID
(detail line)
Cluster IDentifier (1 - 999). The cluster ID of a server who’s state is known
to the server where status ess was run. The detail lines are shown in
cluster ID order.
When status ess is issued on a Main server there is one detail line for
the Main server itself and a detail line for every ESS server that is
registered with the Main server.
When status ess is issued on an ESS server there is only one detail
line since an ESS server only knows its own state.
1 of 2
To Next Page
Loading...
Need help?
General
