22 Bend-Tech Dragon A150
Troubleshooting Guide
Cutting Issues
02
Adjusting Torch Position
In some cases the Operator can adjust the Torch position to compensate for cut rotation.
achieving more accurate cuts.
1. Ensure Torch is centered on the material.
2. Move the A axis left or right .050 in.
3. Run a test cut from this new start position and assess cut rotation. If the cuts are more
accurate, move the Torch in the same direction another .050 in. If the cuts get more
accurate, continue to move the Torch. If the cuts get less accurate, back up to the previous
position. If moving the Torch one direction results in less accurate cuts, move it in the other
direction.
To Next Page
Loading...
Need help?
General
