Name: Bend-Tech DRAGON A150
Brand: Bend-Tech
Rating: 5 (1 reviews)

Other manuals for Bend-Tech DRAGON A150

Original Instructions32 pages

Questions and Answers:

J
Judy TylerAug 2, 2025
Why is the torch not firing on my Bend-Tech Industrial Equipment?
- J
  Jordan ThomasAug 2, 2025
  If the torch on your Bend-Tech Industrial Equipment is not firing, several factors could be at play. First, verify that the Hypertherm is powered on and that all power and control box cables are securely connected. Next, check the torch height using a feeler gauge and perform the Torch Mount procedure. Ensure the air supply and pressure are adequate. Inspect the torch consumables and refer to the Consumables Guide. Check the ground connections, ensuring the clamp is connected and all ground cables are secure. Lastly, confirm that the torch wand switch is turned on.
J
John MendezAug 6, 2025
How to troubleshoot cut quality issues on Bend-Tech Industrial Equipment?
- W
  williamsshawnAug 6, 2025
  If you're experiencing cut quality issues with your Bend-Tech Industrial Equipment, start by inspecting the torch consumables and measuring the pit depth of the electrode. Ensure that the torch height settings in the software and on the machine are correct. Verify that the cutting speed is appropriate for the amperage and material thickness. Also, confirm that the consumables match the amperage settings on the machine and adjust the cut speed accordingly.
J
jose42Aug 11, 2025
What to do if the torch collides with material on Bend-Tech Industrial Equipment?
- A
  abestAug 11, 2025
  If the torch on your Bend-Tech Industrial Equipment is colliding with the material, there are a few things to check. Ensure that the material selected in the software matches the material loaded into the machine. Verify that the material dimensions entered in the Tube Library are accurate. Also, perform the Torch Mount procedure to ensure the torch is set up properly.
J
Johnny CohenAug 15, 2025
Why are the cuts jagged on my Bend-Tech Industrial Equipment?
- B
  Brad RamirezAug 15, 2025
  If you notice jagged cuts on your Bend-Tech Industrial Equipment, it could be due to several reasons. First, ensure that the material feed rate isn't too high. Verify that the amperage is set according to the cutting charts; you might need to adjust it for optimal results. Make sure the material moves freely in the gate without being too tight. Lastly, check the tension on the X cable and adjust it as needed.