ServSwitch™ DKM
2
Wherever long distances cause problems for remotely locating and switching a monitor
(keyboard/mouse) signal, e.g. airports, industrial plants, call centres or in distributed
computer centres, the ServSwitch™ DKM is the best solution to distribute and switch
monitor (keyboard/mouse) signals. Its flexibility allows it to tackle almost every task.
There are 8 pre-configured ServSwitch™ DKMes for CATx as well as an empty chassis for
individual configuration. In addition, there are 4 Media Extenders (DVI + optional audio) and
8 KVM- Extenders (DVI+USB keyboard mouse + optional audio) available. The
transmission of the signals requires connecting CATx cable.
For fibre applications, all switch elements and extenders are also available in multimode or
singlemode versions, requiring the respective cabling.
This manual will tell you all about your new ServSwitch™ DKM, including how to install,
operate and troubleshoot it. For an introduction to the device, see Chapter 2.
The product codes covered in this manual are:
ServSwitch™ DKM Devices for CATx
ACX0808: ServSwitch™ DKM for 8 User and 8 CPUs
ACX0816: ServSwitch™ DKM for 8 User and 16 CPUs
ACX0824: ServSwitch™ DKM for 8 User and 24 CPUs ***
ACX0832: ServSwitch™ DKM for 8 User and 32 CPUs
ACX1608: ServSwitch™ DKM for 16 User and 8 CPUs***
ACX1616: ServSwitch™ DKM for 16 User and 16 CPUs
ACX1624: ServSwitch™ DKM for 16 User and 24 CPUs***
ACX1632: ServSwitch™ DKM for 16 User and 32 CPUs
ACX0000: ServSwitch™ DKM for individual configuration
ServSwitch™ DKM Devices for Multimode/Singlemode and ***marked versions… to
be individually configured, deriving from ACX0000 or others
To Next Page
Loading...
Need help?
General