Home > Network > Network Features > Configure and Operate LDAP Search > Perform an LDAP Search
Using Your Machine's Control Panel
Perform an LDAP Search Using Your Machine's Control Panel
Related Models: ADS-1800W
After you configure LDAP settings, you can use the LDAP search feature to find email addresses to use for
scanning to Email Server.
• The LDAP feature supports LDAPv3.
• You may need to use Kerberos Authentication or Simple Authentication to connect to your LDAP server,
depending on the security policy set by your network administrator.
• You must configure the SNTP protocol (network time server), or you must set the date, time and time
zone correctly on the control panel for Kerberos authentication.
1. Press to search.
2. Enter the initial characters for your search using the LCD.
3. Press [OK].
The LDAP search result will be shown on the LCD; the
icon appears before the email (local) address
book search results.
If there is no match on the server or the email (local) address book, the LCD displays [Results cannot
be found.] for about 60 seconds.
4. Press a or b to display the name you want.
5. Press the name and check the contact information is correct.
6. Press [Apply].
7. Load your document, press [OK], and then press [Start].
Related Information
• Configure and Operate LDAP Search
Related Topics:
• Synchronise Time with the SNTP Server Using Web Based Management
133
To Next Page
Loading...
Need help?
General