Handling sheets
Handling sheets
Selecting the Paper Source
When advancing paper , press the Feeder Selection button and select the source.
Y ou can determine the selected source by checking which lamp is lit-either the Roll Media lamp (a) or the
Cut Sheet lamp (b).
• Roll Media lamp : Selected when printing on Roll Media .
• Cut Sheet lamp : Selected when printing on Sheets from the T op Paper Feed Slot or Front Paper
Feed Slot .
Note
• If any paper is loaded that will not be used, a message is shown on the Display Screen (either Remove
roll? or Eject sheet? ) when you press the Feeder Selection button.
T o remove the paper , press the OK button. ( → P .145)
• Y ou cannot switch the paper source in the following situations:
• When the Message lamp is ashing
Check the message on the Display Screen and take action as necessary . ( → P .684)
• When the Data lamp is ashing
Select the paper source after printing is nished.
• When a printer menu operation is in progress
W ait until the operation is nished before selecting the paper source.
• When in the process of loading paper
Finish loading the paper before selecting the paper source.
• When in the process of replacing ink tanks
Finish replacing the Ink T ank before selecting the paper source.
• When the T op Cover is open
Close the T op Cover before selecting the paper source.
148 Handling Paper
To Next Page
Loading...
Need help?
General