Getti.ng
Started
Charging
the
Battery
Pack
The camcorder can be powered with a
battery pack or directly using the compact
power adapter. Charge the battery pack
before use.
1 Connect the power cord to the
compact power adapter.
2 Plug the power cord into a power
outlet.
3 Connect the compact power adapter
to the camcorder's
DC
IN
terminal.
Remove the battery
terminal cover
before attaching
the
battery pack
4 Attach the battery pack to the
camcorder.
Press the battery pack softly into the
battery attachment unit and slide it up
until it clicks
in
place.
S Charging will start when the
camcorder is turned off.
• The CHARGE indicator starts
flashing. The indicator will go out when
the battery pack
is
fully charged.
•
You
can also use the compact power
adapter without attaching a battery
pack.
• When the compact power adapter is
connected, even if a battery is
attached its power will not be
consumed.
ONCE
THE
BAnERY
PACK
IS
FULLY
CHARGED
1 Disconnect the compact power
adapter from the camcorder.
2 Unplug the power cord from the
power outlet and the compact
power adapter.
To
REMOVE
THE
BAnERY
PACK
Slide [BATTERY RELEASE]
in
the
direction of the arrow and hold it
pressed down. Slide the battery pack
down and then pull it out.
• You may
hear
some noise from the compact
power adapter during use. This is not a
malfunction.
•
We
recommend charging the battery pack in
temperatures between
10°C
and 30 °C (50
OF
and 86
OF).
Outside the temperature range
of
o°C to
40°C
(32
OF
to 104
OF),
the charging will
not start.
• Do not connect to the camcorder's DC
IN
terminal
or
to the compact power adapter any
electrical equipment that is not expressly
recommended for use with this camcorder.
•
To
prevent equipment breakdowns and
excessive heating, do not connect the supplied
To Next Page
Loading...
Need help?
General