II
Connecting to a
TV
or
VCR
.......
--------------------
Connecting
Analog/Digital
Conversion
Using the camcorder you can convert
analog video signals (for example from a
VCR) to digital signals (DV standard only)
and output them to a digital recording
device.
6 When
the
scene
you
wish
to
record
appears,
press
[~/III.
Recording
starts.
7
While
recording,
press
1~/1I1
to
pause
the
recording.
In
record
pause,
press
I~/III
again
to
resume
recording.
S
Press
[j)
to
stop
recording.
9
Connected
device:
Stop
the
playback.
(OJ 12)
Converting
the
Video
Connect the camcorder to the video input
source using an analog connection
-connection
type
II
(CD
71)-
shown in the
previous section
Connection Diagrams.
Connect the camcorder to the recording
device using the digital connection
-connection
type fJ
(CD
71)-
shown in the
same section. Verify that the
DV
terminal on
the external digital device is compatible with
the
DV
standard.
FUNC.
FUNC.
(CD
25)
(J)]oTES
------.--------~
• Blank sections may
be
recorded
as
anomalous picture.
• If the picture does not appear, disconnect the
DV cable and restore the connection after a
short while or turn the camcorder off
and
then
on
again.
•
Do
not connect any devices
to
the
camcorder's USB terminal while
an
external
device
is
connected to the HDV/DV terminal.
•
You
can only record video signals
in
HDV
standard
(1
080i specifications) or
in
DV
standard. Note that signals from identically
shaped DV (IEEE1394) terminals may
be
in
different video standards.
1
Set
[AV... DV]
to
[mD
ON] (OJ 42).
2
Start
the
playback
on
the
video
source
and
the
recording
on
the
recording
device.
Refer
to
the
instruction
manuals
of
the
connected
devices.
• Depending on the signal sent from the
connected device, the conversion from analog
to digital signals might not work properly (e.g.,
signals that include copyright protective signals
or anomalous signals such as ghost signals).
• Usually, leave
[AV'"
DV] set to the default
setting
[BD
OFF]. While it
is
set to [mD ON],
you
cannot connect video input signals
to
the
camcorder using the HDV/DV terminal.
We
recommend powering the camcorder using
the compact power adapter.
Copyright
Signal
Certain software tapes are copyright
protected.
If
you attempt to play back such
tapes, "COPYRIGHT PROTECTED
PLAYBACK IS RESTRICTED" appears and
you will not be able to view the contents
of
the tape. If you attempt to record from such
tapes via the
HDV/DV
terminal,
"COPYRIGHT PROTECTED DUBBING
RESTRICTED" appears and you will not be
able to record the contents
of
the tape.
__
IMPORTANT
)
To Next Page
Loading...
Need help?
General