•
During
the
playback
of
HDV
recordings:
Even
though their icons will appear on screen, the
following special playback modes are not
available.
- Reverse slow playback
- Frame reverse
- Double speed playback (forward
or
reverse)
•
To
protect the tape and video heads, the
camcorder will enter the stop mode
(.)
if left in
playback pause
(~II)
mode for 4 minutes 30
seconds.
To
resume the playback press
[~/II].
Adjusting
the
Volume:
Speaker
and
Headphones
The camcorder plays the sound with the
built-in speaker. When you're using the
viewfinder for playback, you can connect
a pair
of
headphones to listen to the
sound.
You
can also use the headphones
to check the audio level while recording.
Adjusting
the
Volume
of
the
Speaker
([IJ 12)
- +
I~)t'dlldlllil
1 Ifthe joystick guide does not appear
on
screen, press <
8)
to display it.
2 Push the joystick <
....
~
) toward
[±]
or G to adjust the volume.
•
To
turn off the volume completely,
keep pressing (
....
) until the volume
icon changes to
I~~J.
•
You
can press
(8
)again to hide the
joystick guide during playback.
Using
Headphones
The headphones are connected to the
AV/O
terminal, which is used for both the
headphones and the audio/video output.
Before connecting the headphones,
follow the procedure below to change the
function
of
the terminal from AV output to
o (headphones) output and make sure
the 0 icon appears on the screen.
([IJ 12)
• Default value
~
PLAY/OUT
SETUP2
.0.
I
AV/PHONES
I
AV
IAV'
1 Press [FUNC.].
2 Select <
~
) the ra icon and press
(8)
to open the setup menus.
3 Select
(""')
[~ PLAY/OUT
SETUP2]* and press
(8
).
4 Select
(""')
[AV/PHONES] and
press
(8).
5 Select <
..
"')[0 PHONES] and press
(8).
.
To Next Page
Loading...
Need help?
General