----------------------------.-.Trou~~
~
List
of
Messages
•
Some error messages will disappear after being displayed for about 4 seconds.
Message
Explanation/Solution
CD
SET THE TIME ZONE,
You
have not set the time zone, date and time. This message
26
DATE AND TIME
appears each time you turn the power on until you set the time
zone, date and time.
CHANGE THE BATTERY
Battery pack
is
exhausted. Replace or charge the battery pack.
20
PACK
THE TAPE IS SET FOR
Cassette is protected. Replace the cassette or change the position
97
ERASURE PREVENTION
of
the protect switch.
REMOVE THE CASSETTE
Camcorder stopped operating to protect the tape. Remove the
22
cassette and reinsert
it.
CHECK THE HDVIDV
The DV cable is not correctly connected to the HDV/DV terminal, or
71
INPUT
the connected digital device is turned
off.
(Appears only
if
a
DV
cable
is
The video input signal is
in
a different television system (PAL or
-
connected)
SECAM).
CONDENSATION HAS
Condensation has been detected
in
the camcorder.
99
BEEN DETECTED
CONDENSATION HAS
Condensation has been detected
in
the camcorder. Remove the
99
BEEN DETECTED
cassette.
REMOVE THE CASSETTE
TAPE END
Tape reached the end. Rewind the tape or replace the cassette.
-
INCORRECT TAPE
You attempted to play back a tape recorded
in
a different television
-
SPECIFICATION
system (PAL or SECAM) or
in
a recording standard not supported
by this camcorder.
INPUT SIGNAL NOT The digital device connected with the DV cable is incompatible with
-
SUPPORTED the camcorder.
PLAYBACK STD LOCKED
Current camcorder settings do not match the HDV/DV standard
of
42
INCOMPATIBLE VIDEO the video input signal. Change the [PLAYBACK STD] setting to
INPUT
match the video input signal.
PLAYBACK STD LOCKED Current camcorder settings do not match the HDV/DV standard
of
42
PLAYBACK IS
the recording you tried to play back. Change the [PLAYBACK STD]
RESTRICTED to match the recording standard
of
the tape.
HEADS DIRTY, USE Video heads are dirty. Clean the video heads.
99
CLEANING CASSETTE
NO CARD There is no memory card
in
the camcorder.
22
NO IMAGES No images are recorded on the memory card.
-
CARD ERROR
A memory card error occurred. The camcorder cannot record or
-
display the image.
The error may be temporary. If the message disappears after 4
seconds
and"
01
" flashes red, turn the camcorder off, remove the
card and reinsert the card.
If"
01"
changes to green or yellow, you
can continue recording/playback.
CARD FULL
Memory card is full. Erase some images to free some space or
69
replace the memory card.
»
c.
c.
;::;:
o
~
Q)
-
To Next Page
Loading...
Need help?
General