To Next Page

To Previous Page

2.6 Speed Key Setting (Menu code 1160)

( MENU → 1. PLU → 6. Speed Key )

This menu is used to program Speed keys. Speed keys are short-cut keys used to allow

quick access to the most frequently used PLU's in a department. There is also a SHIFT

function that allows you to set a second level of Speed keys that will double the number

of Speed keys available in a department.

You can program up to 5 different Speed Key Sets but only one set can be used in a

department at a time. The Speed Key Set that is used in a department is determined by

Menu code 1211 (chapter 2.2.1.1)

Note: Function keys can be programmed using Menu code 1880 (chapter 2.14.8) and

are assigned to Speed Key locations. If you program Function keys on the CL5000

series you will decrease the total number of Speed Keys available.

1. Speed Key Set No.

• Select speed key set no. You can use this

number when you program menu 1211.

(See the chapter 2.2.1.1)

EX) Speed key set No. = 2

2. Speed Key Programming

• The Speed keys are numbered left-to-right

and top-to-bottom. for standard type, there

are 48 physical keys but using SHIFT key

you can use up to 96 keys. but for pole type,

there are 72 keys if you press the SHIFT key

and then one of the 72 Speed

keys, then you can access Speed keys 73

through 144

EX1) Speed key no. 1

EX2) Speed key no. 49

3. PLU No.

• Enter PLU no. to assign speed key

• PLU should be belong to scale department.

EX1) PLU 10 = BEEF

CAS CL5200 Series User Manual

Questions and Answers: