PurposeCommand or Action
Use the commit command to save the configuration changes to
the running configuration file and remain within the configuration
session.
Note
(Optional) Displays the configuration of the loopback interface.
show interfaces type interface-path-id
Example:
router# show interfaces Loopback 3
Step 5
Verifying the Configuration
You can use the following commands to verify your configuration:
• show mpls l2transport vc—Displays information about Any Transport over MPLS (AToM) virtual
circuits (VCs) and static pseudowires that have been enabled to route Layer 2 packets on the router.
• show mpls tp—Displays information about Multiprotocol Label Switching (MPLS) transport profile
(TP) tunnels.
• show bfd summary—Displays summary information for Bidirectional Forwarding Protocol (BFD).
• show xconnect—Displays information about xconnect attachment circuits and pseudowires.
You can use the following commands to debug your configuration:
• debug mpls tp all—Debug for all MPLS-TP information.
• debug mpls tp cli—Debug for MPLS-TP CLI
• debug mpls tp error—Debug for MPLS-TP errors
• debug mpls tp event—Debug for MPLS events
• debug mpls tp fault-oam—Debug for Fault-OAM
• debug mpls tp ha—Debug for High availability
• debug mpls tp init—Debug for MPLS-TP initialization
• debug mpls tp link-management—Debug for link management
• debug mpls tp link-num—Debug for link number database
• debug mpls tp lsp-db—Debug for LSP database
• debug mpls tp lsp-ep—Debug for endpoint LSP configuration and operation
• debug mpls tp lsp-mp—Debug for midpoint LSP configuration and operation
• debug mpls tp mem—Debug for memory allocation and usage
• debug mpls tp tun-db—Debug for the tunnel database
• debug mpls tp tunnel—Debug for tunnel configuration and operation
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
121
VPLS Configuration over MPLS-TP
Verifying the Configuration
To Next Page
Loading...
Need help?
General
