Cisco ASR 900 Series User Manual

next-address 10.131.159.226
next-address 10.131.191.230
!
!
line con 0
exec-timeout 0 0
line aux 0
line vty 0 4
exec-timeout 0 0
password lab
login
!
end
Device CE2 Configuration
version 12.0
!
hostname ce2
!
enable password lab
!
interface Loopback0
ip address 10.131.159.253 255.255.255.255
no ip directed-broadcast
!
interface GigabitEthernet0/0/2
ip address 10.0.0.2 255.255.255.255
no ip directed-broadcast
no keepalive
no cdp enable
!
end
Verifying That the LSP Is Set Up Correctly
A show mpls forwarding-table command shows that tunnel 1 is in the Multiprotocol Label Switching (MPLS)
forwarding table.
Device# show mpls forwarding-table 10.131.159.252
Local Outgoing Prefix Bytes tag Outgoing Next Hop
tag tag or VC or Tunnel Id switched interface
22 19
[T] 10.131.159.252/32 0 Tu1
point2point
[T] Forwarding through a TSP tunnel.
View additional tagging info with the 'detail' option
A show mpls traffic-eng tunnels tunnel 1 command entered at PE1 displays information about tunnel 1 and
verifies that it is forwarding packets with an out label of 22.
Device# show mpls traffic-eng tunnels tunnel 1
Name: PE1_t1 (Tunnel1) Destination: 10.131.159.251
Status:
Admin: up Oper: up Path: valid Signalling: connected
path option 1, type dynamic (Basis for Setup, path weight 20)
Config Parameters:
Bandwidth: 512 kbps (Global) Priority: 2 2 Affinity: 0x0/0xFFFF
Metric Type: TE (default)
AutoRoute: enabled LockDown: disabled Loadshare: 512 bw-based
auto-bw: disabled
Active Path Option Parameters:
State: dynamic path option 1 is active
BandwidthOverride: disabled LockDown: disabled Verbatim: disabled
InLabel : -
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
90
MPLS LSP Ping, Traceroute, and AToM VCCV
ICMP ping and trace Commands and Troubleshooting

Cisco ASR 900 Series Specifications

General

Brand	Cisco
Model	ASR 900 Series
Category	Network Router
Language	English