Cisco ASR 900 Series User Manual

Table 12: Other MPLS LSP Ping and Traceroute and AToM VCCV Options
DescriptionOption
Size of the packet with the label stack imposed.
Specified with the size packet-size keyword and
argument. The default size is 100.
For use with the MPLS LSP Ping feature only.
Datagram size
Padding (the pad time-length-value [TLV]) is used
as required to fill the datagram so that the MPLS echo
request (User Datagram Protocol [UDP] packet with
a label stack) is the size specified. Specify with the
pad pattern keyword and argument.
For use with the MPLS LSP Ping feature only.
Padding
Parameter that enables you to send a number of
packets of different sizes, ranging from a start size to
an end size. This parameter is similar to the Internet
Control Message Protocol (ICMP) ping sweep
parameter. The lower boundary on the sweep range
varies depending on the label switched path (LSP)
type. You can specify a sweep size range when you
use the ping mpls command. Use the sweep minimum
maximum size-increment keyword and arguments.
For use with the MPLS LSP Ping feature only.
Sweep size range
Number of times to resend the same packet. The
default is 5 times. You can specify a repeat count
when you use the ping mpls command. Use the
repeat count keyword and argument.
For use with the MPLS LSP Ping feature only.
Repeat count
Routable address of the sender. The default address
is loopback0. This address is used as the destination
address in the Multiprotocol Label Switching (MPLS)
echo response. Use the source source-address
keyword and argument.
For use with the MPLS LSP Ping and Traceroute
features.
MPLS echo request source address
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
76
MPLS LSP Ping, Traceroute, and AToM VCCV
Command Options for ping mpls and trace mpls

Cisco ASR 900 Series Specifications

General

Brand	Cisco
Model	ASR 900 Series
Category	Network Router
Language	English