Cisco ASR 900 Series User Manual

0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Step 6
show mpls forwarding-table
Displays contents of the Multiprotocol Label Switching (MPLS) Label Forwarding Information Base (LFIB). Look for
information on multilink interfaces associated with a point2point next hop.
Example:
Device# show mpls forwarding-table
Local Outgoing Prefix Bytes tag Outgoing Next Hop
tag tag or VC or Tunnel Id switched interface
16 Untagged 10.30.0.1/32 0 Mu6 point2point
17 Pop tag 10.0.0.3/32 0 Mu6 point2point
18 Untagged 10.0.0.9/32[V] 0 Mu10 point2point
19 Untagged 10.0.0.11/32[V] 6890 Mu10 point2point
20 Untagged 10.32.0.0/8[V] 530 Mu10 point2point
21 Aggregate 10.34.0.0/8[V] 0
22 Untagged 10.34.0.1/32[V] 0 Mu10 point2point
Use the show ip bgp vpnv4 command to display VPN address information from the Border Gateway Protocol (BGP)
table.
Example:
Device# show ip bgp vpnv4 all summary
BGP router identifier 10.0.0.1, local AS number 100
BGP table version is 21, main routing table version 21
10 network entries using 1210 bytes of memory
10 path entries using 640 bytes of memory
2 BGP path attribute entries using 120 bytes of memory
1 BGP extended community entries using 24 bytes of memory
0 BGP route-map cache entries using 0 bytes of memory
0 BGP filter-list cache entries using 0 bytes of memory
BGP using 1994 total bytes of memory
BGP activity 10/0 prefixes, 10/0 paths, scan interval 5 secs
10.0.0.3 4 100 MsgRc52 MsgSe52 TblV21 0 0 00:46:35 State/P5xRcd
Step 7
exit
Returns to user EXEC mode.
Example:
Device# exit
Device>
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
59
MPLS Multilink PPP Support
Verifying the Multilink PPP Configuration

Cisco ASR 900 Series Specifications

General

Brand	Cisco
Model	ASR 900 Series
Category	Network Router
Language	English