Cisco ASR 900 Series User Manual

PurposeCommand or Action
Exits MPLS-TP LSP forward LSP configuration
mode.
exit
Example:
Device(config-mpls-tp-lsp-forw)# exit
Step 6
Enters MPLS-TP LSP reverse LSP configuration
mode.
reverse-lsp
Example:
Device(config-mpls-tp-lsp)# reverse-lsp
Step 7
Specifies the in-label, out-label, and out-link
numbers.
in-label num out-label num out-link num
Example:
Device(config-mpls-tp-lsp-rev)# in-label 22000
out-label 20000 out-link 44
Step 8
Exits the MPLS TP LSP configuration mode and
returns to privileged EXEC mode.
end
Example:
Device(config-mpls-tp-lsp-rev)# end
Step 9
Configuring MPLS-TP Links and Physical Interfaces
MPLS-TP link numbers may be assigned to physical interfaces only. Bundled interfaces and virtual interfaces
are not supported for MPLS-TP link numbers.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface type number
4.
ip address ip-address mask
5.
mpls tp link link-num{ipv4 ip-address tx-mac mac-address}
6.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
31
MPLS Transport Profile
Configuring MPLS-TP Links and Physical Interfaces

Cisco ASR 900 Series Specifications

General

Brand	Cisco
Model	ASR 900 Series
Category	Network Router
Language	English