Cisco Nexus 1000V User Manual

3-11
Cisco Nexus 1000V Troubleshooting Guide, Release 5.2(1)SV3(1.1)
OL-31593-01
Chapter 3 Installation
Recreating the Cisco Nexus 1000V Installation
Removing Hosts from the Cisco Nexus 1000V DVS
You can remove hosts from the Cisco Nexus 1000V DVS.
BEFORE YOU BEGIN
• Log in to vSphere Client.
• Know the name of the Cisco Nexus 1000V DVS to remove from vCenter Server.
DETAILED STEPS
Step 1 From vSphere Client, choose Inventory > Networking.
Step 2 Choose the DVS for the Cisco Nexus 1000V and click the Hosts tab.
The Host tab opens.
Step 3 Right-click each host, and choose Remove from Distributed Virtual Switch.
The hosts are now removed from the DVS.
Removing the Cisco Nexus 1000V from the vCenter Server
You can remove the Cisco Nexus 1000V DVS from vCenter Server.
BEFORE YOU BEGIN
• Log in to the VSM CLI in EXEC mode.
DETAILED STEPS
Step 1 From the Cisco Nexus 1000V VSM, use the following commands to remove the DVS from the vCenter
Server.
a. config t
b. svs connection vc
c. no vmware dvs
Example:
switch# conf t
switch(config)# svs connection vc
switch(config-svs-conn)# no vmware dvs
switch(config-svs-conn)#
The DVS is removed from vCenter Server.
Step 2 You have completed this procedure.
Return to the “Flowchart: Re-creating the Cisco Nexus 1000V Installation” section on page 3-10.

Cisco Nexus 1000V Specifications

General

Type	Virtual Switch
Manageable	Yes
NetFlow	Yes
SPAN	Yes
ERSPAN	Yes
Operating System	Cisco NX-OS
Form Factor	Virtual
Hypervisor Support	VMware ESXi
Features	VXLAN
Security Features	Port Security, Private VLANs, ACLs