x
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
OL-16478-03
About this Guide
Organization
The major sections of this guide are as follows:
Chapter Title Description
1 Cisco Service Control Overview, page 1-1 This chapter provides a brief introduction to
Cisco Service Control.
2 Introduction to the Cisco SCE8000 Platform,
page 2-1
This chapter provides a hardware overview of
the SCE8000 platform.
3 Cisco SCE8000 Topology and
Topology-Related Parameters, page 3-1
This chapter describes the possible
deployment topologies of the SCE8000 and
explains how various aspects of the topology
determine the configuration of the system.
4 Installing the Cisco SCE8000 Chassis,
page 4-1
This chapter explains how to install a
SCE8000 platform in the rack and properly
ground it.
5 Connecting the Management Interfaces,
page 5-1
This chapter explains how to connect the
SCE8000 platform to a local console and
perform the initial system configuration via
the setup wizard that runs automatically.
6 Cabling the Line Ports and Completing the
Installation, page 6-1
This chapter provides instructions for cabling
the Gigabit Ethernet ports for both one and
two SCE8000 topologies, and for configuring
Gigabit Ethernet (GBE) interface parameters.
In a topology utilizing two SCE8000s
(cascade), this includes the cascade ports as
well as the line ports.
7 Basic Cisco SCE8000 Platform Operations,
page 7-1
This chapter describes how to start up the
SCE8000 platform, reboot, and shutdown. It
also describes how to manage configurations.
8 Troubleshooting, page 8-1 This chapter provides basic system startup
troubleshooting information.
9 Removal and Replacement Procedures,
page 9-1
This chapter explains the procedures for
removing and replacing the power supplies,
fan trays, and other modules.
A Using Optical Splitters with 10GBE Links,
page A-1
This appendix supplies important information
regarding supported and not supported optical
splitter configurations in the 10GBE
environment.
To Next Page
Loading...
Need help?
General
