Cisco SCE8000 Installation And Configuration Guide

CHAPTER
9-1
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
OL-16478-03
9
Removal and Replacement Procedures
This chapter describes how to perform removal and replacement procedures for Cisco SCE8000 platform
field-replaceable units (FRUs).
Warning Before you install, operate, or service the system, read the Regulatory Compliance and Safety
Information for the Cisco SCE8000 . This guide contains important safety information you should know
before working with the system.
• Safety, page 9-1
• Preventing Electrostatic Discharge Damage, page 9-2
• Supported Hardware, page 9-3
• Removing and Replacing the Power Supply, page 9-3
• Removing and Replacing the Fan Assembly, page 9-11
• Removing and Replacing Modules, page 9-13
• Removing and Replacing Shared Port Adapters, page 9-23
• Removing and Replacing the Optical Bypass Module, page 9-26
Safety
Warning Before working on a chassis or working near power supplies, unplug the power cord on AC units;
disconnect the power at the circuit breaker on DC units.
Warning The plug-socket combination must be accessible at all times because it serves as the main
disconnecting device.
Warning Class 1 laser product.

Cisco SCE8000 Specifications

General

Brand	Cisco
Model	SCE8000
Category	Network Hardware
Language	English