7-16
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
OL-16478-03
Chapter 7 Basic Cisco SCE8000 Platform Operations
How to Display the System Uptime
How to Display the System Uptime
Use this command to see how long the system has been running since the last reboot.
Step 1 At the SCE> prompt, type show system-uptime and press Enter.
Example for Displaying the System Uptime
The following example shows how to display the system uptime of the SCE platform.
SCE#show system-uptime
Cisco SCE8000 uptime is 21 minutes, 37 seconds
Rebooting and Shutting Down the SCE Platform
• Rebooting the SCE Platform, page 7-16
• How to Shut Down the SCE Platform, page 7-17
Rebooting the SCE Platform
Rebooting the SCE platform is required after installing a new package, in order for that package to take
effect. There might be other occasions where rebooting the SCE platform is necessary.
Note When the SCE restarts, it loads the startup configuration, so all changes made in the running
configuration will be lost. You are advised to save the running configuration before performing reload,
as described in Saving or Changing the Configuration Settings, page 7-6.
Step 1 At the SCE# prompt, type reload and press Enter.
A confirmation message appears.
Step 2 Type y to confirm the reboot request and press Enter.
Examples for Rebooting the SCE Platform
The following example shows the commands for system reboot.
SCE# reload
Are you sure? y
the system is about to reboot, this will end your CLI session
To Next Page
Loading...
Need help?
General
