Cisco SCE8000 Installation And Configuration Guide

CHAPTER
7-1
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
OL-16478-03
7
Basic Cisco SCE8000 Platform Operations
This chapter describes how to start up the Cisco SCE8000 platform, reboot, and shutdown. It also
describes how to manage configurations.
• Starting the Cisco SCE8000 Platform, page 7-1
• Managing Cisco SCE8000 Configurations, page 7-5
• How to Display the SCE Platform Version Information, page 7-10
• How to Display the SCE Platform Inventory, page 7-12
• How to Display the System Uptime, page 7-16
• Rebooting and Shutting Down the SCE Platform, page 7-16
Starting the Cisco SCE8000 Platform
The procedures for starting the Cisco SCE8000 platform are explained in the following sections:
• Checking Conditions Prior to System Startup, page 7-1
• Performing Complex Configurations, page 7-2
• Starting the System and Observing Initial Conditions, page 7-2
• Final Tests, page 7-3
Checking Conditions Prior to System Startup
Check the following conditions before you start your Cisco SCE8000 platform:
• Both power supply units are installed and connected. (If only one power supply is connected it will
put the box in warning state.)
• First-time startup at installation:
– Cisco SCE8000 platform connected to local console (CON port)
– The console terminal is turned on and properly configured
• Subsequent startups
– Line interfaces are properly cabled (optional)
– Cisco SCE8000 platform is connected to at least one of the following types of management
stations:

Cisco SCE8000 Specifications

General

Brand	Cisco
Model	SCE8000
Category	Network Hardware
Language	English