5 Servers
5-4
VPN 3000 Concentrator Series User Guide
Find your selected Server Type below.
Server Type = RADIUS
Configure these parameters for a RADIUS (Remote Authentication Dial-In User Service) authentication
server.
Figure 5-3: Configuration | System | Servers | Authentication | Add or Modify RADIUS screen
Authentication Server
Enter the IP address or hostname of the RADIUS authentication server; e.g., 192.168.12.34.
Maximum 32 characters. (If you have configured a DNS server, you can enter a hostname in this field;
otherwise, enter an IP address.)
Server Port
Enter the UDP port number by which you access the server. Enter 0 (the default) to have the system
supply the default port number,
1645.
Timeout
Enter the time in seconds to wait after sending a query to the server and receiving no response, before
trying again. Minimum is
1 second, default is 4 seconds, maximum is 30 seconds.
Retries
Enter the number of times to retry sending a query to the server after the timeout period. If there is still
no response after this number of retries, the VPN Concentrator declares this server inoperative and uses
the next RADIUS authentication server in the list. Minimum is
0, default is 2, maximum is 10 retries.
To Next Page
Loading...
Need help?
General