13 Policy Management
13-34
VPN 3000 Concentrator Series User Guide
Configuration | Policy Management | Traffic Management |
Assign Rules to Filter
This section of the Manager lets you add, remove, and prioritize the rules in a filter, and assign Security
Associations to rules that are configured with an
Apply IPSec action.
A filter applies its rules to data packets coming through the system, in the order the rules are arranged
on the filter. If a rule matches, the system takes the
Action specified in the rule. If not, it applies the next
rule; and so on. If no rule matches, the system takes the
Default Action specified in the filter.
The Manager groups applied rules by direction (inbound or outbound), with inbound rules first. You can
prioritize rules only within a direction.
You configure rules on the
Configuration | Policy Management | Traffic Management | Rules screens.
Notes: Rules affect the operation of the filter as soon as you add, remove, or prioritize them. If the filter is being
used by an active interface or group, changes may affect data traffic.
Be careful about adding or changing rules on the
Public (Default) filter. You could compromise security.
Figure 13-15: Configuration | Policy Management | Traffic Management | Assign Rules to Filter
screen
Filter Name:
The name of the filter whose rules you are configuring. You cannot change this name here. (See
Configuration | Policy Management | Traffic Management | Filters | Modify.)
To Next Page
Loading...
Need help?
General