Cisco VPN 3000 User Manual

CLI menu reference
16-9
VPN 3000 Concentrator Series User Guide
1.1 Configuration > Interface Configuration
This table shows current IP addresses.
.
.
.
Model
3015–3080 only
1) Configure Ethernet #1 (Private)
2) Configure Ethernet #2 (Public)
3) Configure Ethernet #3 (External)
4) Configure Power Supplies
5) Configure Expansion Cards
6) Back
Interfaces -> _
Model 3005 only 1) Configure Ethernet #1 (Private)
2) Configure Ethernet #2 (Public)
3) Configure Power Supplies
4) Configure Expansion Cards
5) Back
Interfaces -> _
1.1.1, 1.1.2, or 1.1.3 Configuration > Interface Configuration > Configure Ethernet #1 or #2 or #3
Only 1.1.1 and 1.1.2
on Model 3005
1) Enable/Disable
2) Set IP Address
3) Set Subnet Mask
4) Select IP Filter
5) Select Ethernet Speed
6) Select Duplex
7) Set Port Routing Config
8) Set Public Interface
9) Back
Ethernet Interface 1 -> _
1.1.4 Configuration > Interface Configuration > Configure Power Supplies
Model
3015–3080 only
Alarm Thresholds in centivolts (e.g. 361 = 3.61V)
Voltages will be adjusted to conform to the hardware.
1) Configure CPU voltage thresholds
2) Configure Power Supply 1 voltage thresholds
3) Configure Power Supply 2 voltage thresholds
4) Configure Board voltage thresholds
5) Back
Interfaces -> _

Cisco VPN 3000 Specifications

General

Brand	Cisco
Model	VPN 3000
Category	Switch
Language	English