Cisco VPN 3000 User Manual

Configuration | Policy Management | Traffic Management | Filters
13-29
VPN 3000 Concentrator Series User Guide
Configuring a filter involves two steps:
1 Configuring its basic parameters (name, default action, etc.) by clicking
Add Filter, Modify Filter, or
Copy Filter, and
2 Assigning rules to a filter by clicking
Assign Rules to Filter.
You apply filters to interfaces under
Configuration | Interfaces, and these are the most important filters for
security since they govern all traffic through an interface. You also apply filters to groups and users
under
Configuration | User Management, and thus govern tunneled traffic through an interface.
Caution: The Cisco-supplied default filters and rules are intended as templates that you should examine and
configure to fit your network and security needs. If incorrectly configured, they could present security
risks. You should also be especially careful about adding rules to the
Public (Default) filter, which allows
only tunneled and ICMP traffic.
Figure 13-13: Configuration | Policy Management | Traffic Management | Filters screen

Cisco VPN 3000 Specifications

General

Brand	Cisco
Model	VPN 3000
Category	Switch
Language	English