Cisco XR 12000 Series User Manual

authentication (L2TP)
To enable L2TP authentication for a specified L2TP class name, use the authentication command in L2TP
class configuration mode. To return to the default behavior, use the no form of this command.
authentication
no authentication
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
L2TP class configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
You can also enable L2TP authentication for a specified class name from L2TP class configuration
submode. To enter this submode, enter the l2tp-class command followed by the class name.
Note
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to configure L2TP authentication for the specified L2TP class name
“cisco”:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# l2tp-class cisco
RP/0/0/CPU0:router(config-l2tp-class)# authentication
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
4 OL-28460-01
Virtual Private Network Commands
authentication (L2TP)

Cisco XR 12000 Series Specifications

General

Brand	Cisco
Model	XR 12000 Series
Category	Network Router
Language	English