Cisco XR 12000 Series User Manual

interface (p2p)
To configure an attachment circuit, use the interface command in p2p configuration submode. To return to
the default behavior, use the no form of this command.
interface type interface-path-id [PW-Ether | PW-IW]
no interface type interface-path-id [PW-Ether | PW-IW]
Syntax Description
Interface type. For more information, use the question mark (?) online help function.
type
Physical interface or a virtual interface.
Use the show interfaces command to see a list of all possible interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
(Optional) Configures an Ethernet Interface.PW-Ether
(Optional) Configures an IP Interworking Interface.PW-IW
Command Default
None
Command Modes
p2p configuration submode
Command History
ModificationRelease
This command was introduced.Release 3.4.0
The following keywords were added:
•
PW-Ether
•
PW-IW
Release 4.2.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
OL-28460-01 35
Virtual Private Network Commands
interface (p2p)

Cisco XR 12000 Series Specifications

General

Brand	Cisco
Model	XR 12000 Series
Category	Network Router
Language	English