Cisco XR 12000 Series User Manual

bridge group (VPLS)
To create a bridge group so that it can contain bridge domains and then to assign network interfaces to the
bridge domain, use the bridge group command in L2VPN configuration mode. To remove all the bridge
domains that are created under this bridge group and to remove all network interfaces that are assigned under
this bridge group, use the no form of this command.
bridge group bridge-group-name
no bridge-group bridge-group-name
Syntax Description
Number of the bridge group to which the interface belongs.
bridge-group-name
Command Default
No bridge group is created.
Command Modes
L2VPN configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the bridge group command to enter L2VPN bridge group configuration mode.
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows that bridge group 1 is assigned:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# l2vpn
RP/0/0/CPU0:router(config-l2vpn)# bridge group 1
RP/0/0/CPU0:router(config-l2vpn-bg)#
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
OL-28460-01 161
Virtual Private LAN Services Commands
bridge group (VPLS)

Cisco XR 12000 Series Specifications

General

Brand	Cisco
Model	XR 12000 Series
Category	Network Router
Language	English