Cisco XR 12000 Series User Manual

pw-class encapsulation mpls
To configure MPLS pseudowire encapsulation, use the pw-class encapsulation mpls command in L2VPN
pseudowire class configuration mode. To undo the configuration, use the no form of this command.
pw-class class-name encapsulation mpls {control word| ipv4| load-balancing| preferred-path| protocol
ldp| redundancy one-way| sequencing| tag-rewrite| transport-mode| vccv verification-type none}
no pw-class class-name encapsulation mpls {control word| ipv4| load-balancing| preferred-path| protocol
ldp| redundancy one-way| sequencing| tag-rewrite| transport-mode| vccv verification-type none}
Syntax Description
Encapsulation class name.
class-name
Disables control word for MPLS
encapsulation. Disabled by default.
control word
Sets the local source IPv4 address.ipv4
Sets flow label-based load
balancing.
load-balancing
Configures the preferred path
tunnel settings.
preferred-path
Configures LDP as the signaling
protocol for this pseudowire class.
protocol ldp
Configures one-way PW
redundancy behavior in the
Redundancy Group.
redundancy one-way
Configures sequencing on receive
or transmit.
sequencing
Configures VLAN tag rewrite.tag-rewrite
Configures transport mode to be
either Ethernet or VLAN.
transport-mode
Enables or disables the VCCV
verification type.
vccv none
Command Default
None
Command Modes
L2VPN pseudowire class configuration
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
OL-28460-01 69
Virtual Private Network Commands
pw-class encapsulation mpls

Cisco XR 12000 Series Specifications

General

Brand	Cisco
Model	XR 12000 Series
Category	Network Router
Language	English