Cisco XR 12000 Series User Manual

l2transport propagate
To propagate Layer 2 transport events, use the l2transport propagate command in interface configuration
mode. To return to the default behavior, use the no form of this command.
l2transport propagate remote-status
no l2transport propagate remote-status
Syntax Description
Propagates remote link status changes.remote-status
Command Default
None
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The l2transport propagate command provides a mechanism for the detection and propagation of remote
link failure for port mode EoMPLS.
To display the state of l2transport events, use the show controller internal command in Cisco IOS XR
Interface and Hardware Component Configuration Guide for the Cisco XR 12000 Series Router
For more information about the Ethernet remote port shutdown feature, see Cisco IOS XR MPLS Configuration
Guide for the Cisco XR 12000 Series Router.
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to propagate remote link status changes:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# interface GigabitEthernet 0/0/0/0
RP/0/0/CPU0:router(config-if)# l2transport propagate remote remote-status
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
OL-28460-01 47
Virtual Private Network Commands
l2transport propagate

Cisco XR 12000 Series Specifications

General

Brand	Cisco
Model	XR 12000 Series
Category	Network Router
Language	English