Cisco XR 12000 Series User Manual

switching-tlv (L2VPN)
To advertise the switching point type-length variable (TLV) in the label binding, use the switching-tlv
command in the pseudowire class configuration mode. To disable the display of the TLV, use the no form of
this command.
switching tlv hide
no switching tlv
Syntax Description
Hides TLV.hide
Command Default
Switching point TLV data is advertised to peers.
Command Modes
L2VPN pseudowire class encapsulation mode
Command History
ModificationRelease
This command was introduced.Release 4.1.1
Usage Guidelines
The pseudowire switching point TLV information includes the following information:
•
Pseudowire ID of the last pseudowire segment traversed
•
Pseudowire switching point description
•
Local IP address of the pseudowire switching point
•
Remote IP address of the last pseudowire switching point that was crossed or the T-PE router
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writel2vpn
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
140 OL-28460-01
Virtual Private Network Commands
switching-tlv (L2VPN)

Cisco XR 12000 Series Specifications

General

Brand	Cisco
Model	XR 12000 Series
Category	Network Router
Language	English