Cisco XR 12000 Series User Manual

l2transport
To configure a physical interface to operate in Layer 2 transport mode, use the l2transport command in
interface configuration mode. To return to the default behavior, use the no form of this command.
l2transport
no l2transport
This command has no arguments or keywords.
Command Default
None
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.4.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The l2transport command and these configuration items are mutually exclusive:
•
IPv4 address and feature (for example, ACL) configuration
•
IPv4 enable, address and feature (for example, ACL) configuration
•
Bundle-enabling configuration
•
L3 subinterfaces
•
Layer 3 QoS Policy
After an interface or connection is set to Layer 2 switched, commands such as ipv4 address are not usable.
If you configure routing commands on the interface, l2transport is rejected.
Note
Task ID
OperationsTask ID
read, writel2vpn
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
OL-28460-01 43
Virtual Private Network Commands
l2transport

Cisco XR 12000 Series Specifications

General

Brand	Cisco
Model	XR 12000 Series
Category	Network Router
Language	English