Cisco XR 12000 Series User Manual

Examples
The following example shows how to configure the bundle Ethernet interface as an attachment circuit:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# l2vpn
RP/0/0/CPU0:router(config-l2vpn)# bridge group 1
RP/0/0/CPU0:router(config-l2vpn-bg)# bridge-domain bar
RP/0/0/CPU0:router(config-l2vpn-bg-bd)# interface gigabitethernet 0/1/0/9
RP/0/0/CPU0:router(config-l2vpn-bg-bd-ac)#
Related Commands
DescriptionCommand
Establishes a bridge domain, and enters L2VPN bridge group bridge
domain configuration mode.
bridge-domain (VPLS), on page 159
Creates a bridge group so that it can contain bridge domains and
then to assign network interfaces to the bridge domain.
bridge group (VPLS), on page 161
Enters L2VPN configuration mode.l2vpn, on page 49
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
170 OL-28460-01
Virtual Private LAN Services Commands
interface (VPLS)

Cisco XR 12000 Series Specifications

General

Series	XR 12000
Product Type	Router
Category	Network Router
Architecture	Distributed
Maximum Slots	16
Number of Slots	16
Routing Protocol	BGP, OSPF, IS-IS, EIGRP, RIP
Operating System	Cisco IOS XR
Form Factor	Chassis
Supported Interfaces	Ethernet
Management	CLI, SNMP
Power Supply	AC
Interfaces/Ports	Multiple, depending on line cards
Ports	Multiple, depending on line cards

Summary

Virtual Private Network Commands

authentication (L2TP) Command

Enables L2TP authentication for a specified L2TP class name.

l2vpn Command

Enters L2VPN configuration mode.

neighbor (L2VPN) Command

Configures a pseudowire for a cross-connect.

pw-class (L2VPN) Command

Enters pseudowire class submode to define a pseudowire class template.

p2p Command

Enters p2p configuration submode to configure point-to-point cross-connects.

timeout setup (L2TP) Command

transport mode (L2VPN) Command

tunnel-template Command

xconnect group Command

Virtual Private LAN Services Commands

action (VPLS) Command

Configures bridge behavior when learned MAC addresses reach the MAC limit.

bridge-domain (VPLS) Command

Establishes a bridge domain and enters L2VPN bridge group configuration mode.

bridge group (VPLS) Command

Creates a bridge group to contain bridge domains and assign interfaces.

limit (VPLS) Command

mac (VPLS) Command

maximum (VPLS) Command

mtu (VPLS) Command

neighbor (VPLS) Command

shutdown (Bridge Domain) Command

time (VPLS) Command

vfi (VPLS) Command