Cisco XR 12000 Series User Manual

The following sample output shows the MAC address on a specified interface on a specified bridge:
RP/0/0/CPU0:router# show l2vpn forwarding bridge-domain g1:bd1 mac-address 1.2.3 location
0/1/CPU0
Mac Address Type Learned from/Filtered on LC learned Age
--------------------------------------------------------------------------------
0001.0002.0003 static Gi0/1/0/0 N/A N/A
The following sample output shows the hardware information from the egress pse:
RP/0/0/CPU0:router# show l2vpn forwarding bridge-domain g1:bd1 mac-address hardware egress
location 0/1/CPU0
Mac Address Type Learned from/Filtered on LC learned Age
--------------------------------------------------------------------------------
0000.0000.0000 static Gi0/1/0/0 N/A N/A
0000.0001.0101 dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.0102 dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.0103 dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.0104 dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.0105 dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.0106 dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.0107 dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.0108 dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.0109 dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.010a dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.010b dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.010c dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.010d dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.010e dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.010f dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.0110 dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.0111 dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.0112 dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.0113 dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
0000.0001.0114 dynamic Gi0/1/0/0 0/1/CPU0 0d 0h 2m 24s
...
The following sample output shows the MAC addresses that are learned on a specified pseudowire on a
specified bridge:
RP/0/0/CPU0:router# show l2vpn forwarding bridge-domain mac-address neighbor 1.1.1.1 pw-id
1 location 0/1/CPU0
Mac Address Type Learned from/Filtered on LC learned Age
--------------------------------------------------------------------------------
0000.0003.0101 dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.0102 dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.0103 dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.0104 dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.0105 dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.0106 dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.0107 dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.0108 dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.0109 dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.010a dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.010b dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.010c dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.010d dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.010e dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.010f dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.0110 dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.0111 dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.0112 dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.0113 dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.0114 dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
0000.0003.0115 dynamic 1.1.1.1, 1 0/1/CPU0 0d 0h 0m 30s
...
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
208 OL-28460-01
Virtual Private LAN Services Commands
show l2vpn forwarding bridge-domain mac-address (VPLS)

Cisco XR 12000 Series Specifications

General

Series	XR 12000
Product Type	Router
Category	Network Router
Architecture	Distributed
Maximum Slots	16
Number of Slots	16
Routing Protocol	BGP, OSPF, IS-IS, EIGRP, RIP
Operating System	Cisco IOS XR
Form Factor	Chassis
Supported Interfaces	Ethernet
Management	CLI, SNMP
Power Supply	AC
Interfaces/Ports	Multiple, depending on line cards
Ports	Multiple, depending on line cards

Summary

Virtual Private Network Commands

authentication (L2TP) Command

Enables L2TP authentication for a specified L2TP class name.

l2vpn Command

Enters L2VPN configuration mode.

neighbor (L2VPN) Command

Configures a pseudowire for a cross-connect.

pw-class (L2VPN) Command

Enters pseudowire class submode to define a pseudowire class template.

p2p Command

Enters p2p configuration submode to configure point-to-point cross-connects.

timeout setup (L2TP) Command

transport mode (L2VPN) Command

tunnel-template Command

xconnect group Command

Virtual Private LAN Services Commands

action (VPLS) Command

Configures bridge behavior when learned MAC addresses reach the MAC limit.

bridge-domain (VPLS) Command

Establishes a bridge domain and enters L2VPN bridge group configuration mode.

bridge group (VPLS) Command

Creates a bridge group to contain bridge domains and assign interfaces.

limit (VPLS) Command

mac (VPLS) Command

maximum (VPLS) Command

mtu (VPLS) Command

neighbor (VPLS) Command

shutdown (Bridge Domain) Command

time (VPLS) Command

vfi (VPLS) Command