BODY PANELS
15
What is covered by this chapter
The intent of this chapter is to describe the removal
and disassembly of the major body panels on the trac-
tor.
•Hood
•Seat
• Fenders
• Dash panel
NOTE: It is not absolutely necessary to remove
the mowing deck for any procedures covered in
this section. The technician may choose to
remove the mowing deck so that it is easier to
reach some parts of the tractor.
NOTE: The hood described in this section is the
“A” style hood. Other styles may be produced
for different markets (e.g.: over-seas) or future
style changes. See Figure 4.1.
Figure 4.1
“A” style hood
Hood
Hood removal:
1. The hood is front-hinged. See Figure 4.2.
2. Open the hood by lifting the rear edge to tilt it for-
ward.
3. Disconnect the headlight wires. See Figure 4.3.
NOTE: The ground terminals and power termi-
nals on the headlights are two different sizes.
The green wires (ground) fit the larger terminals.
The red wires (power) fit the smaller terminals.
Figure 4.2
Lift here
Figure 4.3
Inset: headlight detail
CHAPTER 4: BODY PANELS
To Next Page
Loading...
Need help?
General