HYDRO. DRIVE AND BRAKE SYSTEM
38
Pedal shaft assembly removal
NOTE: Confirm that the parking brake is
released before starting work.
1. Remove the mowing deck.
2. Remove the fenders, as described in the body
panels chapter of this manual.
3. Disconnect the rod that joins the arm at the left
side of the brake/clutch shaft to the drive belt
tensioner pulley bracket. See Figure 5.22.
• Remove and discard the cotter pin to disconnect
the rod.
4. Remove the locking clip that holds the travel limit
pin in place.
5. Withdraw the travel limit pin. See Figure 5.23.
6. Unhook the clutch/brake pedal return spring.
See Figure 5.24.
7. Remove and discard the push cap that holds the
drive control pedal shaft onto the clutch/brake
shaft. See Figure 5.25.
Figure 5.22
Clutch/brake shaft Rod
Figure 5.23
Travel limit pin
Latch plates
Figure 5.24
Clutch/brake pedal
return spring
Hooks to clutch/brake
latch plate
Hooks to frame
Figure 5.25
Tie-rod
separator
Push cap
To Next Page
Loading...
Need help?
General