BODY PANELS
17
Hood components: grill removal
1. Remove the hood assembly from the tractor, and
place it on a stable work surface.
2. Loosen, but do not remove the screws that hold
the upper corners of the grill to the hood using a
3/8” wrench. See Figure 4.8.
3. Remove the two screws that hold the pivot
bracket and grill to the hood assembly using a 1/
2” wrench. See Figure 4.9.
Figure 4.8
Grill
Slotted mounting hole
Screw +
washer
Figure 4.9
Pivot bracket
Large Screws
Hood
Grill
4. Once removed, the headlight lens may be
removed for cleaning by carefully prying the two
lock tabs at the inner edge. See Figure 4.10.
NOTE: The locating tab at the outer edge of
each lens has no locking feature.
NOTE: Replacement lenses are not presently
available.
5. Assemble and install the grill by reversing the
steps used to remove it.
• Tighten the small screws to a torque of 15-35 in-
lbs. (1.7-4.0 N-m).
• Tighten the large screws to a torque of 35-50 in-
lbs (4.0-5.7 N-m).
Figure 4.10
Lock tabs
Locating tab
To Next Page
Loading...
Need help?
General