Design Guide | iC7 Series Liquid-cooled System Modules
Figure 107: Attaching Mounting Plates to Each Other
1 Lip
2. Attach the mounting plates onto the cabinet with screws by the 4 mounting holes in the corners of the mounting plates.
The screws are not included in the delivery. Use an M4/M5 screw.
8.12 Installing the Control Unit
Install the control unit to the selected location. Use the 4 mounting holes in the corners of the mounting plate.
8.13 Installing Boards to the Modular Control Unit
NOTICE
DAMAGE TO OPTION BOARDS
Do not install, remove, or replace option boards on the drive when the power is on. Doing this can cause damage to the boards.
l Switch off the AC drive before installing, removing, or replacing option boards on the drive.
NOTICE
For best performance, install the Option Extender OC7F2 next to the control unit in 1 of the first 2 slots.
1. Remove the screw that is pre-attached to the fixing point at the top of the mounting plate and keep it.
2. Slide the lower edge of the board to the mounting plate fixing point.
Danfoss Drives Oy © 2024.03 AJ475942178716en-000101 / 172K2848A | 109
To Next Page
Loading...
Need help?
General
