Understanding the Printer Menus 197
Default Color
Purpose:
To specify the color mode to Color or Black. This setting is used for a print job which does not specify a print mode.
Va lu es :
Network
Use the Network menu to change the printer settings affecting jobs sent to the printer through the wired or
wireless network.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Ethernet
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes effective after the
printer is turned off and then on again.
Va lu es :
Wireless Status
NOTE: Wireless Status feature is available only when the printer is connected using the wireless network.
Purpose:
To confirm the wireless communication status.
Va lu es :
Wireless Setup
NOTE: Wireless Setup is available only when the printer is connected using the wireless network.
Purpose:
To configure the wireless network interface.
Color
*
Prints in the color mode.
Black Prints in the black and white mode.
Auto
*
Detects the Ethernet settings automatically.
10BASE- T Half Uses 10BASE-T Half-duplex.
10BASE- T Full Uses 10BASE-T Full-duplex.
100BASE- TX Half Uses 100BASE-TX Half-duplex.
100BASE- TX Full Uses 100BASE-TX Full-duplex.
1000BASE- T Full Uses 1000BASE-T Full-duplex.
Connection (Good)
(Acceptable)
(Low)
(No Reception)
SSID Displays the name that identifies the wireless network.
Enc. Displays the encryption type.
To Next Page
Loading...
Need help?
General