Steps
1. Locate the touchpad slot on your computer.
2. Align and place the touchpad into the slot on your computer.
3. Replace the four (M2x2) screws to secure the touchpad to the plamrest.
4. Connect the touchpad cable to the connector on the system board and secure the latch.
5. Adhere the adhesive to secure the touchpad to the palmrest.
6. Align and place the touchpad bracket.
7. Replace the three (M2x2) screws to secure the touchpad bracket to the touchpad.
8. Adhere the adhesive to route the speaker cable.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The figure indicates the location of the power-adapter and provides a visual representation of the removal procedure.
44
Removing and installing components
To Next Page
Loading...
Need help?
General
