Boot options
Table 3. Boot options
Option Description
Boot sequence Displays the following information:
● Windows Boot Manager
● UEFI Hard Drive
● ONBOARD NIC (IPV4)
● ONBOARD NIC (IPV6)
Add/Remove/View Boot Devices Allows you to:
● Add Boot Option
● Remove Boot Option
● View
UEFI Boot Path Security Controls whether or not the system will prompt the user to enter the admin password (if
set) when booting to a UEFI boot path device from the F12 boot menu.
● Never
● Always
● Always Except Internal HDD
System information
Table 4. System Configuration
Option Description
Date/Time This option controls the system date and time. Changes to the date/time take effect
immediately.
● Date format: MM/DD/YYYY
● Time format: HH/MM/SS 24 hour format. You can switch between 12 hr and 24 hr clock.
Network controller
configuration
Displays the following information:
● Integrated NIC: If enabled, UEFI networking protocols are installed and available, allowing
pre-OS and early OS networking features to use any enabled NICs. This option controls:
○ Disabled
○ Enabled
○ Enabled with PXE
● Enable UEFI Network Stack: (enabled by default)
Storage Interface Displays the following:
● Port Enablement: This page allows you to select the onboard drives you would like to
enable.
○ SATA-0 (enabled by default)
○ M.2 PCIe SSD-0/SATA-2 (enabled by default)
SATA operatoin Allows you to set the operating mode of the integrated SATA hard drive controller.
● Disabled
● AHCI
● RAID on (enabled by default)
Drive information Displays the following information:
● SATA-0
○ Type
○ Device
● M.2 PCIe SSD-0/SATA-2
○ Type
○ Device
System setup 67