Domino Ax Series User Manual

MAINTENANCE
5-14 EPT019297 Issue 1 November 2016
(13) Re-connect the power lead to the rear of the printer.
(14) Press and hold the power button for 2 seconds and wait for the printer to start.
(15) Attach a new ink cartridge to the ITM or re-use the existing ink cartridge. See, “Ink and
Make-up Cartridge Replacement” on page 5-4.
(16) Check the ink compartment for leaks.
(17) The status lights on the Quality Management Module (QMM) will flash amber to indicate that
the RFID tags on the ITM, Ink Cartridge and Make-up Cartridge are being read. When the
RFID tags have successfully been read and validated, the status lights will turn green.
Notes: (1) If fault is detected, the QMM status lights will turn red and an alert will be displayed on
the Status tab.
(2) If the RFID tag cannot be read, or an RFID tag is not present, the QMM status lights
will turn solid amber.
(18) Shut the ink compartment access door.
(19) Dispose of contaminated paper towels and the old ITM by following local waste disposal
regulations.
End of procedure.
Quality Management Module Status Lights
Ink Cartridge
ITM
Make-up
Cartridge

Domino Ax Series Specifications

General

Brand	Domino
Model	Ax Series
Category	Printer
Language	English