INSTALLATION
EPT019297 Issue 1 November 2016 3-37
Print Trigger
Home > Setup > Production Line Setup > Print Trigger
Printing can be triggered by one of two different methods which are described in the table below.
Note: It is recommended to use the external print trigger if the space between products
varies on the production line.
Internal Print Trigger Setup
To setup a simulated print trigger signal internally at fixed distance intervals:
(1) On the TouchPanel, select Home > Setup > Production line setup > Print trigger.
(2) Select the Trigger by drop down setting and select Internal.
(3) Select the Print delay (mm) setting and set the delay for the first label after a production run
begins.
(4) Select the Distance interval (mm) setting and set the distance between each printed label.
Note: If the “Print trigger occurred while printing” alert is displayed, increase the Print delay
(mm) value so that it is larger than the width of the label.
End of procedure.
Print Trigger Method Explanation
Internal Generate a simulated print trigger signal internally at fixed
distance intervals. To setup an internal print trigger, follow the
procedure described on page 3-37.
External Use an external product sensor to generate a print trigger signal.
To setup an external print trigger, follow the procedure described
on page 3-38.
To Next Page
Loading...
Need help?
General
