INSTALLATION
3-16 EPT019297 Issue 1 November 2016
PC to Networked Printer Settings
To setup the PC to Printer network settings:
(1) Install the QuickStep programme on the PC which will be used to control the printer.
(2) Ensure the printer is correctly connected to the network.
(3) On the printer’s TouchPanel, select Home > Setup > Printer network.
(4) Tick the Enable Ethernet tick box.
(5) Select Edit...
(6) Ensure the Enable DHCP tick box is selected.
(7) If required, change the IP address of the printer so that it is in the same range as the PC. For
example, if the PC’s IP address is 192.168.1.5 change the printers IP address to
192.168.1.55.
(8) Select the green Tick icon.
(9) Make a note of the Host name and IP address.
(10) Start the QuickStep programme on the PC.
(11) Select the Lock icon.
(12) Select Unlock UI settings.
(13) Enter the UI password (Default password: QS).
(14) Select the green Tick icon.
(15) Select OK.
(16) Select the UI Settings icon.
(17) Select the Connection Method drop down setting and select one of the options described
below:
(18) Depending on the option selected at the previous step, select either Add direct... or Add
favourite...
Connection Method Explanation
Broadcast This feature is currently not available
Favourite Create a list of favourite printers if there are multiple Ax-Series
printers available in the network.
Direct Connect to a single printer on the network.
To Next Page
Loading...
Need help?
General
