INSTALLATION
20509 Issue 7 Jan 2018 A-19
(8) Pass the ink feed pipe through the hole in the bulkhead plate.
Continue sliding the connections and feed pipe into the cabinet until
the conduit fits into the rear panel.
(9) Screw on the retaining nut and washer. Tighten the nut sufficiently to
make the conduit secure.
(10) Remove the plastic cover from the 37-way connector. Plug the
connector into the motherboard. For connection details see the table
below.
Print Head
Feed Pipe
TP7175_2
Print Head
Connector
Adding a new Print Head
To Next Page
Loading...
Need help?
General
